Painting rocker cover

  1. #1
    Ok is there a how to guide in here on painting the rocker cover? Hate to ask a dumb Q but what is under the rocker cover...? When you remove it are the internals of the cam etc exposed?
  2. #2
    You should see the cam underneath the rocker mate. Not sure if there's a how to guide though.

    Just clean it up, sand it down, prime it, spray it and laquer it.
  3. #3
    spot on advice from dan. make sure you use a heat resistant paint above the primer as it will start to bubble like mine did
  4. #4
    Cheers sounds like a plan... any colour reccomendations for a possi blue VTR?
  5. #5
    I used a heat resistant paint, but looked a bit dull so went over it in silver hammerite and it looks really good now!
  6. #6
    posi blue would look good or even white. depends if your painting anything else. have a look at my engine in my thread about my car and u will get an idea of what to paint.
  7. #7
    I did mine silver, looks tidy..
  8. #8
    Did mine gunmetal, bloody bastard fannymould heatsheilds startin to bubble aready though
  9. #9
    Was thinking of Red today? What grade of sandpaper dya need to use and how much rubbing is needed? Juast enough to key the primer?