I have a KFW 1.4 8v with the rad cap on the plastic reservuair.
So, a month ago, a cold morning, started driving and suddenly I see the temperature needle raising above the middle, for the first time since I bought the car, 2 years ago.
After a while it dropped below the middle and stayed there.
I got home after some 40 kilometers of driving, parked and saw coolant on the ground. It was from the cap. The cap was loose, I tighten it and drive again.
Started driving again and the cap flys off and I lose it somewhere in the road losing almost 2.5liters of coolant.
I change the cap, perfectlly seals and tightens(unlike the before), added coolant, bled the system and still the same, temp raises to approx. 3/4 and sometimes the red light comes on.
It depends on driving for example if I am going on a hill and there's load on the car the temp raises, but on a downhill road without me pressing the gas pedal it stays in the middle.
I have to note that rad is full of coolant and I bled the system from all the 3 bleeding screws several times.
Thermostat seems to work fine as the upper hose is hot which means the coolant is circulating.
Radiator fans start turning when the temp needle reaches just before 3/4 (which I believe is the normal thing to happen) and close when temp goes to middle.
What am I missing here?
May be water pump?
Clogged rad?
I don't know ...
It is like "after the cap incident" something went wrong.
PLEASE HELP
So, a month ago, a cold morning, started driving and suddenly I see the temperature needle raising above the middle, for the first time since I bought the car, 2 years ago.
After a while it dropped below the middle and stayed there.
I got home after some 40 kilometers of driving, parked and saw coolant on the ground. It was from the cap. The cap was loose, I tighten it and drive again.
Started driving again and the cap flys off and I lose it somewhere in the road losing almost 2.5liters of coolant.
I change the cap, perfectlly seals and tightens(unlike the before), added coolant, bled the system and still the same, temp raises to approx. 3/4 and sometimes the red light comes on.
It depends on driving for example if I am going on a hill and there's load on the car the temp raises, but on a downhill road without me pressing the gas pedal it stays in the middle.
I have to note that rad is full of coolant and I bled the system from all the 3 bleeding screws several times.
Thermostat seems to work fine as the upper hose is hot which means the coolant is circulating.
Radiator fans start turning when the temp needle reaches just before 3/4 (which I believe is the normal thing to happen) and close when temp goes to middle.
What am I missing here?
May be water pump?
Clogged rad?
I don't know ...
It is like "after the cap incident" something went wrong.
PLEASE HELP
