I have have brought a raceland manifold and am still unsure on how to relocated the oil filter! anyone know anything about this?
relocation of oil filter vtr
-
#1
-
#2This site's pretty good mate:
http://www.enjoythedrive.com/content/?id=26242
Here's a thread from on here
http://www.saxperience.com/forum/showthread.php?t=54701 -
#3do a search mate, there is a good guide on here somewhere
-
#4Also found this for you dude
http://www.pgrobinson.com/CX/filter_relocation.html
What most people do is simply buy a Mk1 oil filter and thread from citroen, they will probably have to order the thread that holds the filter though but said that it's the easiest way and IIRC it was less than £10. Just make sure you block the whole where the Oil dip stick goes as it wont stay in place with a Mk2 one maybe try a Mk1, when iv helped to it in the past i never bothered, just covered the whole.
Good luck, keep it posted
-
#5just buy a mk1 oil filter, problem solved!
-
#6Soz didnt mean to undercut u matey
but your right
-
#7Cheers redbullet 07 wat a legend you are lol cheers mate
-
#8Cheers mate, rep welcome when you get a few more posts

Post some pics up when its on and sorted as adz21 on here is getting one of the racelands and has the same problem
-
#10Not too hard mate, just fiddly. Il help you do it when the time comes with ur dad if he's around or just take it down to Owens, he'll do it for cheap and pretty quickly once its up on the ramp
-
#11Might take Owen's up on that... would be so much easier than farting around at home doing it.
-
#12Much lol
-
#13
-
#14Good guide mate
-
#15Thanks m8
-
#16legend finchy can easily see what to do on my turbo now
-
#17gdgd glad to be able to help u out
wat turbo u got/doin?
-
#18Car is a 106 quiksilver but the 1.4 overheated and died horribaly think f1 smoke screen!
had a 1.1 full engine from a 2002 saxo in the garage.......
full details are over on ssc in the project section
ta for the guide is alot of help -
#19its all fitted now me and in_da_weeds carried it out on friday nite. The only think not metioned in your guide is the fact that we had 2 modifie the oil pressure sensor cause the manifold was hitting it when we put it on. So we had 2 hacksaw it shorter and replace the connector the a small slide on pin.
-
#20ye i need to put that in, i managed to melt mine lol so now its nice and short and got some more wire and covered in foil and its all good now no problems so far
